Iron and Manganese Filtration

Iron And Manganese Filtration

Water in underground springs and boreholes can dissolve Iron and Manganese from the surrounding rocks.

The water under ground is devoid of Oxygen, and the Iron and Manganese are soluble in water because of this.

However, when the water is pumped to the surface and exposed to the Oxygen in the air, the Iron and Manganese become insoluble. This cause them to precipitate out of the water, leaving deposits in your tanks, pipes and taps.

Lubron can supply Iron and Manganese Filtration equipment to oxidize and filter these contaminants before they enter your water system.

Iron and Manganese can affect equipment and systems and are therefore often minimized by treating the water. For the iron removal and demanganization of water, the (spring) water is brought into intensive contact with oxygen. In various sub-processes, via oxidation, hydrolysis, nucleation and precipitation, the Iron and Manganese are ultimately filtered out. In this process the 2-valued, soluble forms of Iron and Manganese present in the water are converted into very poorly soluble forms.

As a result of this physicochemical process (also known as electrokinetic adsorption), it becomes possible to filter the Iron and Manganese particles. For this, use is made of annealed and sieved river sand, which is selected on the basis of the supply water and the desired end result. The first precipitation of Iron Hydroxide has a positive effect on the further precipitation of both Iron and Manganese.

Due to this catalytic effect, clean filter sand must run in for some time before the Iron removal starts properly. The same principle applies to the demining process. The final quality of the de-ironed water depends on various parameters such as the pH value (acidity) of the water, the oxygen concentration, the buffering capacity of the source water, the flow rate, and the selection of the filter medium.

Lubron manufacture and supply Iron removal systems from 100l/h up to 150m3/h.

The filters are based on an extensive range of high quality steel vessels, built to the latest European standards, with excellent internal access.

The manifolds, available in PVC or, to special order, stainless steel, incorporate
pneumatic or motorised backwash control valves, which are governed by a dedicated programmable microprocessor unit.

FAQs

Why do I have orange deposits in my tanks?

You may have high Iron levels in your incoming water. Exposure to the air in your tanks is causing the Iron to oxidise and precipitate out of solution in your tanks.

Why does my water becomes discoloured after being exposed to air?

It is possible that you have either Iron or Manganese in your water, which is oxidising on contact with the air. A water analysis will reveal how bad your problem is and allow us to manufacture a solution.